Catalyst Athletics Forums

Catalyst Athletics Forums (http://www.catalystathletics.com/forum/index.php)
-   Powerlifting, Strongman & Grip Training (http://www.catalystathletics.com/forum/forumdisplay.php?f=33)
-   -   How much strength necessary to deadlift a car (http://www.catalystathletics.com/forum/showthread.php?t=5569)

Kevin Shaughnessy 07-10-2010 10:55 PM

How much strength necessary to deadlift a car
 
Im curious how much deadlift strength it takes to deadlift your standard 4 door car as it looks like quite the bad ass feat. Anyone have an idea?

Thanks.

Tom Vale 07-11-2010 05:19 AM

550lb from mid knee. Maybe.

Don Stevenson 07-12-2010 12:56 AM

It depends very much on the way the car is set up for the deadlift and the weight distribution of the vehicle in question.

In most cars the heaviest bit of the car is directly over the front wheels which is also the pivot point for the deadlift (assuming you are lifting from the rear and thus you don't actually need to "lift" the engine.

In strongman competitions it's common to have the car on a frame where the back wheels are supported about halfway along a lever with the pivot point under the middle of the car and the lifting bar is at the other end of the lever.

In this case you are lifting roughly 50% of whatever weight is through the rear wheels, normally from a partial DL position.

So while it looks bad ass it's not actually as hard as it looks

Which is why Tom was able to lift the car for reps at the last comp he went it :D

Tom Vale 07-12-2010 02:36 AM

Quote:

Originally Posted by Don Stevenson (Post 78157)
It depends very much on the way the car is set up for the deadlift and the weight distribution of the vehicle in question.

In most cars the heaviest bit of the car is directly over the front wheels which is also the pivot point for the deadlift (assuming you are lifting from the rear and thus you don't actually need to "lift" the engine.

In strongman competitions it's common to have the car on a frame where the back wheels are supported about halfway along a lever with the pivot point under the middle of the car and the lifting bar is at the other end of the lever.

In this case you are lifting roughly 50% of whatever weight is through the rear wheels, normally from a partial DL position.

So while it looks bad ass it's not actually as hard as it looks

Which is why Tom was able to lift the car for reps at the last comp he went it :D

15 reps mofo.

I was referring to simply lifting a car without a frame. My deadlift is about 15lbs shy of 500lb, so I figure that with another 50lb I could lift a heavier car for 1 rep...


All times are GMT -7. The time now is 06:04 PM.

Powered by vBulletin Version 3.6.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.