Home   |   Contact   |   Help

Get Our Newsletter
Sign up for our free newsletter to get training tips and stay up to date on Catalyst Athletics, and get a FREE issue of the Performance Menu journal.

Go Back   Catalyst Athletics Forums > Training > Equipment

Reply
 
Thread Tools Display Modes
Old 06-09-2013, 09:07 PM   #1
Mitch Medeiros
New Member
 
Join Date: Jan 2013
Posts: 1
Default Necesity of multiple layered platform

How necessary is it to build a platform with multiple levels of plywood?

I've seen a ton of designs with two sheets lengthwise, then two sheets on top of them, then the top layer is rubber and some decent grade wood.

I know some places just drop a single sheet of ply in between mats, usually right on top of the cement floor. Does that not cut it?

Also, I've seen some (like the ones at California Strength) that look like a ton of 2x6's stacked up side by side.

So again, what's the benefit of the extra cost of a couple more layers of ply?
Mitch Medeiros is offline   Reply With Quote
Old 06-12-2013, 02:37 PM   #2
Christian Boivin
New Member
 
Join Date: Jun 2013
Posts: 2
Default

I would say to do a couple layers for a home gym, or if you are running an oly gym.
Residential concrete is not the same as commercial in a lot of areas, your home will need more protection.
If you are using something like hi-temps, you might get away with just mats and a piece of wood with moderate usage and moderate weight.
If you are using a competition style plate, have higher lifts, or will do daily training on it, take the time to build a proper platform

I would say it is like a seatbelt, you might never need it, but the one time you get in an accident you would be damn happy you were wearing it.
You might never damage your floor, but if you did you would be damn sorry you didn't spend the extra $$ for another couple sheets of 3/4'' osb

So for a home gym, spend the money on plywood instead of foundation repair.
Christian Boivin is offline   Reply With Quote
Old 06-14-2013, 05:09 PM   #3
Blake Barnes
Moderator
 
Blake Barnes's Avatar
 
Join Date: May 2013
Posts: 304
Default

Stacking several pieces of plywood on top of each other and screwing them together help prevent the possibility of the wood warping or creating any type of "bubbles".

As far as dropping one piece of ply in your matted floor, you definitely need to make sure the concrete below it is good quality. I also believe that way will have a greater chance of the wood warping, especially if your area's weather fluctuates a lot along with the humidity.

The best way to go is just to lay out a couple stacks of plywood to keep the platform flat and solid.
__________________
Blake Barnes
Blake Barnes is offline   Reply With Quote
Old 06-15-2013, 04:51 AM   #4
Chris Rice
Member
 
Join Date: Jul 2007
Posts: 53
Default

Go to the experts - hopefully that's the place you will be buying your concrete from and explain what you want to do. There are more options than you might first be aware of besides just the thickness of the pour. Richer (stronger) mix - fiber in the mix - screen or rebar reinforcement etc. I have seen first hand what impact loads too a small area (like bumpers hitting the same spot repeatedly) and it ain't pretty - and redoing it is tough at that point (and expensive). The secret is spreading the stress out and that's why the multilayer plywood platform works so much better than the rubber alone. As stated before a well compacted base, an appropriate thickness or the correct type mix. with some type of reinforcement such as screen or rebar - then a suitable multilayer platform. Don't be penny wise and pound foolish.
Chris Rice is offline   Reply With Quote
Old 08-14-2013, 03:29 PM   #5
John Janecek
New Member
 
Join Date: Jun 2012
Posts: 35
Default

Oh man where do I start on this....

Been doing this for 23 years now and have ALWAYS put two sheets of plywood down with one more sheet on the top in the middle then two strips of rubber along the side...

Have went as thin as 1/4" plywood and rubber and the floor and platforms have held up for years and years...In my garage, in junior highs, in high schools etc...

Get to my new job in a brand new 6,000 sq ft wtroom with 22 platforms in a high school (1/4' rubber flooring with a heavy duty 3/4" rubber 4x8 rubber mat on top) and within a year I have a spot on the flooor where it was wire mesh and its desinigrated a spot 2x2'......

Order 66 sheet of plywood and split all the rubber mats into 2x8 sections. Put down two 3/4" sheets with another sheet on top and the rubber strips along the side. Within a year I have two more spots to repair-ends up costing about $5k...

Now we added TWO MORE sheets under each platform so we have platforms with three 3/4" sections of plywood or rubber.....

Cross your fingers and whoever said a penny of prevention and pound of....well, you get it now....

Heres the awesome bumpers we used on them too, never buy anything from Troy Barbell/ USA Sports

http://youtu.be/pltvQAvOrZM
John Janecek is offline   Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -7. The time now is 03:57 PM.

Powered by vBulletin Version 3.6.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Subscribe to our Newsletter


Receive emails with training tips, news updates, events info, sale notifications and more.
ASK GREG

Submit your question to be answered by Greg Everett in the Performance Menu or on the website

Submit Your Question
WEIGHTLIFTING TEAM

Catalyst Athletics is a USA Weightlifting team of competitive Olympic-style weightlifters with multiple national team medals.

Read More
Olympic Weightlifting Book
Catalyst Athletics
Contact Us
About
Help
Newsletter
Products & Services
Gym
Store
Seminars
Weightlifting Team
Performance Menu
Magazine Home
Subscriber Login
Issues
Articles
Workouts
About the Program
Workout Archives
Exercise Demos
Text Only
Instructional Content
Exercise Demos
Video Gallery
Free Articles
Free Recipes
Resources
Recommended Books & DVDs
Olympic Weightlifting Guide
Discussion Forum
Weight Conversion Calculator