Though I would post this here for everyone. I tried to post to the Xfit message boards but apparently I have made some enemies and my stuff simply does't show up.
We own a prior affiliate and chose after several years to no longer contribute financially to Greg Glassman for personal reasons, however, I still enjoy much of the community and want to be helpful.
When we were cutting mats for the new lifting platforms we discovered a better way to cut them and I thought I would share.
We used 6x4 3/4 inch thick mats. We chalked our lines and used a carpentry knife to create a guide point; then we got a hack saw with a very fine blade and cut through the mats like butter. It took us on avg. about 25 seconds a mat and the lines came out smooth and the mats locked together well.
Hopefully, this is helpful.
We can, we must, we will find a way