View Single Post
Old 05-09-2011, 08:21 AM   #4
Patrick Donnelly
Senior Member
Patrick Donnelly's Avatar
Join Date: Aug 2007
Posts: 713

Didn't work. I took my angle grinder to it for a good 45 minutes, but the area cleared by each pass was way too narrow to make much of a difference, and it took multiple passes to get down to bare wood again. While it could give the bare wood a new, rougher texture, it still didn't turn out nearly as good as the original.

Don't even think about trying this with a handheld wire brush; you won't get anywhere.

In the future, I'll simply by a new piece of plywood or rely some sort of floor wax to get the proper surface.
And yes, I'm actually holding that handstand. Get on my level.
Patrick Donnelly is offline   Reply With Quote